2017 Toyota Tundra
Mileage
141,568
Service Date
3/20/2026
Services Performed
- Using a oil pressure gauge, we noticed the engine oil pressure at idle speed with no loads and normal operating temperature at 12.0 psi. According to the service manual the pressure should be 10.0 psi or more. During a test drive the oil pressure fluctuates consistently from 12.0 psi to above 60.0 psi depending on engine RPM. Recommend, as a precautionary measure, to replace the oil pressure sensor and monitor the oil pressure gauge.
- TREAD LIFE REMAINING L/F_4_/32 R/F_4_/32 L/R_7_/32 R/R_7_/32 TIRE PRESSURE F_35_psi R_35_psi SPARE_x_psi. BRAKE LIFE REMAINING: F_5.0_MM R_4.0_MM SHOES_x_MM BATTERY VOLTAGE _12.9_V SPEC_650_CCA TESTED @ _653_CCA NOTE: Both front tires are showing signs of uneven wear to due out of alignment.
- ENGINE OIL PRESSURE – Check
- Replace both bulb on the rear license plate.
- CONTROL ARM – Remove & Replace – Upper,Both – [DOES NOT include alignment.]
- PreRroad test vehicle. Report any noise or vibration or pulling of the suspension. Set tire pressure to specifications. Adjust front and rear alignment angles to factory recommended specifications. Report needed repairs of worn out suspension components. Road test vehicle and verify proper operation.
- Replace the drive belt.
- Road test for power steering operation. Inspect system for leaks. Flush power steering lines, pump, rack and pinion, and or gear box. Fill system with new power steering fluid and Road test vehicle.
- Install new rear brake pads and resurface rotors. Lubricate caliper slide pins and assemble. Adjust brake fluid level and road test vehicle.
- Replaced both rear brake rotors. No labor charge.
Osvaldo A. gave our service a 5 star review on 3/21/2026
